SHOPPING CART
Your Cart is Empty
Spinner
contact-phone
CALL CENTER
+44 208 638 0906

ALL BRANDS

Telematica is the exclusive representative of leading companies in motorsports and electronics. Browse our wide range of manufacturers and equip your vehicle with products of high quality and performance.

VIEW ALL BRANDS
  • CloseMENU

Stator - Molded - Harley Davidson - 22 Amp - 81-88 Big Twin

Molded Stator, Lectric for Harley-Davidson

ACCEL Performance
Supplier : ACCEL Performance
Part Number : 152103
Barcode : 743047608258
ERP Code : ACC-0669

Made from the finest components available, these high quality ACCEL Motorcycle Lectric stators are precision machine-wound and produce the highest output possible. The windings are then coated to maintain isolation of the pure copper windings from potential grounding sources. Some part numbers are available in an over molded configuration for maximum isolation. As always, ACCEL believes in providing the highest quality products and backs each stator with a limited lifetime replacement warranty. Stator, Lectric, Molded, Harley-Davidson.

13.UPS
Official ACCEL Performance Distributor
Supplier Warranty
* Trace your package anytime via tracking number that we will send you via SMS and email

product details

Charging Problems

Check the Stator:

  1. Disconnect the regulator from the stator at the terminal inside the crankcase.
  2. Check for continuity between either stator pin and the crankcase. Continuity indicates that the stator is grounded and needs to be replaced.
  3. Check the resistance between the stator pins. A reading of 0.1 to 0.2 ohms should be present. A lower reading requires that the stator be replaced.

Check the Output:

  1. Again disconnect the regulator, and connect a voltmeter set to AC volts across the stator terminals. With the engine running at 2000 rpm, there should be a reading of 32-40 AC volts. The output will increase or decrease 16-20 AC volts for every 1000 rpm.

Check the Current Draw:

  1. With all accessories, ignition, and headlamp high beam turned on, read the current draw.
  2. The current draw should be at least 3.5 Amps lower than the output listed in the SPECIFICATIONS section of the Harley-Davidson service manual. You may have too many accessories drawing power for the system to handle.

How Do I Polarize My Generator?

  1. A generator that is not polarized will burn relay points, cause a dead battery, or damage to the generator.
  2. Momentarily touch a jumper wire between the BAT and GEN terminals on the generator.

related products

CONTACT US
+44 208 638 0906
Call Center
Telematica Contact Email
Email Message
WORKING HOURS
Monday - Friday 9:00 - 20:00
Saturday - Sunday Closed
W3C HTML5 validator